PuttBayYour Mevo and this PC must be on the same Wi-Fi connection. Join the network named FS M2-... in Windows. For online rounds and updates while the PC is on the Mevo's Wi-Fi, plug in Ethernet or use a second Wi-Fi adapter. Close FS Golf on the phone and PC before playing if it still holds the unit.
With a FlightScope GSPro license
GSPro drives your Mevo. GSPro Connect switches between full shots, chips and putts. GSPro putts for you on this license; PuttBay's practice green still uses your camera. To use the Mevo for putts, follow FlightScope's placement guide: move it closer to the ball and set the recommended tilt. Register the unit in FS Golf while you have internet if it has stopped getting ready.
Follow these steps
In the PuttBay app, these steps are interactive: the app performs the checks for you and provides the named buttons. Here they are plain instructions you can read on any device.
- 01
Join the Mevo's Wi-Fi
Do this in Windows
Switch on the Mevo. In Windows Wi-Fi, choose its FS M2-... network. Keep Ethernet or a second Wi-Fi adapter for internet.
- 02
Open GSPro
GSPro Connect owns the Mevo on your FlightScope license. PuttBay watches GSPro and keeps the practice green available.
With a GSPro open connection license
Install flighthook yourself from the community release page. PuttBay finds your copy, points its shot connection at PuttBay, starts it minimized, and lets you reconnect or stop it from the launch monitor tile. Put flighthook back as it was restores the connection settings PuttBay changed. PuttBay does not install flighthook or talk to the Mevo itself.
Your camera handles putts in GSPro rounds on this route. flighthook uses GSPro's selected club to change Mevo modes for chips. If a short chip is missed, check that GSPro shows your wedge before swinging. You can use Reconnect launch monitor from Home or this page if flighthook stops responding.
Follow these steps
In the PuttBay app, these steps are interactive: the app performs the checks for you and provides the named buttons. Here they are plain instructions you can read on any device.
- 01
Join the Mevo's Wi-Fi
Do this in Windows
Join FS M2-... in Windows. Use Ethernet or a second Wi-Fi adapter for internet while the Mevo occupies Wi-Fi.
- 02
Choose flighthook in PuttBay
Open Launch monitor setup and choose Mevo+ / Mevo Gen2 through flighthook. Install flighthook yourself if PuttBay has not found it yet.
- 03
Connect and hit a shot
Once GSPro is connected, choose Connect it. Hit a full shot and check the launch monitor tile. Pick a wedge in GSPro before a short chip. Use your putting camera when GSPro selects the putter.
The original Mevo is a different unit. It does not provide the ball direction needed for GSPro simulation and is not offered as a launch monitor here.